Table of Contents
Advertisement
Installation and
Operation
This section details the installation of the FOXBOX Tx/Rx, including:
•
•
•
•
Installation Overview
Follow these steps to install and set up an Extron FOXBOX transmitter and receiver system
for operation:
1.
2.
3.
4.
Mounting the Units
Detailed mounting instructions can be found in
on page 41. Any of the 1-inch high, quarter-rack width units can be placed on a tabletop,
mounted on a rack shelf, mounted under or through a desk or other furniture, or mounted to
a projector bracket.
Compatible optional hardware is listed on the Extron website.
ATTENTION:
Installation Overview
Mounting the Units
Connections and Configuration
Operation
Turn off all of the equipment. Ensure that the video sources and the output display are
all turned off and disconnected from the power source.
Mount the transmitter and one or more receivers (see "Mounting the Units").
Connect the cables and configure the receivers (see
on the next page).
Plug in the power supplies, then turn on the display devices and the input devices.
•
Installation and service must be performed by authorized personnel only.
•
L'installation et l'entretien doivent être effectués uniquement par un électricien
qualifié.
Connections and Configuration
Mounting the Transmitter or Receiver
FOXBOX Tx / Rx • Installation and Operation
7
Advertisement
Table of Contents
