Starting The Program - Extron electronics FOXBOX Tx VGA MM User Manual

Starting the Program

Start the Extron FOX Extenders Control program as follows:
1. Click
Start
Program
The
Communication Setup
1 1 1 1 1 1 1 1 1 1
2 2 2 2 2 2 2 2 2 2
Figure 15.
2. If necessary, click the
3.
Select the Com port to which your transmitter or receiver is connected. Click
( ).
2
The
FOX Extenders Control Program
Figure 16.
NOTE: Only one fiber optic cable, transmitter-Tx-to-receiver-Rx, is required for serial
command transmission. But, if you connect only one fiber optic cable, there will be
reduced control program functionality on the Rx unit. For full functionality, install
both fiber optic cables and leave the FOXBOX receiver in normal mode (Mode DIP
switch 1 down).
> >
All Programs Extron Electronics
> .
FOX Extenders
dialog box appears (figure 15).
Communication Setup Window
tab (see figure 15,
RS-232
FOX Extenders Control Program Window
>
FOX Extenders Control
).
1
window appears (figure 16).
FOXBOX Tx / Rx • Remote Control
Connect
30