Table of Contents
Advertisement
Audio Output Level radio buttons — Click either the
figure 18
on the previous page,
to select the output audio level.
NOTE: When you make an audio output level change, the setting is changed in the
receiver. It reports the changes to the transmitter via the optional receiver-Tx-to-
transmitter-Rx cable.
If the PC is connected to the transmitter and either the
receiver-Tx-to-transmitter-Rx cable is not connected in
your system or the receiver is in the daisy chain mode, the
program cannot report the output audio level in the Audio
Adjustment panel. You can change the level, but the
program cannot report the changes. The program shows
the
(or
Set Consumer
Set Professional
to indicate that the output level command is control
only, not an indication (see figure 19). The message is
displayed for approximately 1 second.
Memory Preset panel
The
panel provides a means to save and recall memory presets. Memory
Memory Preset
presets are stored values of the horizontal and vertical position and sizing information saved
in nonvolatile memory. When the FOXBOX unit is powered down and later powered back
up, the settings are available for selection using the
to a preset using the
Save
preset.
Mute panel
Click the
(
) radio button, the
£
Video Mute
panel to turn the video and audio mutes on and off.
Mute
NOTES:
•
When the video output is RGB and the output is muted,the receiver mutes the
red, green, and blue planes, but leaves the sync plane(s) (horizontal and vertical or
composite sync) live so that there is no loss of sync in the display device.
•
When you mute or unmute the output, the setting is
changed in the receiver. It reports the changes to the
transmitter via the optional receiver-Tx-to-transmitter-
Rx cable.
If you are connected to the transmitter and either the
receiver-Tx-to-transmitter-Rx cable is not connected in
your system or the receiver is in the daisy chain mode,
you can still mute the output in the
program cannot report the position values. The
(or
)
video
audio
mute On
for approximately 1 second (figure 20).
) or
7
Professional Level (+4 dBu)
) level message
Recall
button (
) overwrites the settings previously written to that
¢
Audio Mute
panel, but the
Mute
or
message is displayed
Off
FOXBOX Tx / Rx • Remote Control
Consumer Level (-10 dBV)
(
) radio button
8
Figure 19.
Alternate
Audio Adjustment
Panel Indication
button (
). Saving the settings
9
radio button (
), or both in the
¤
Figure 20.
Alternate
Mute Panel Indication
Set
(see
33
Advertisement
Table of Contents
Need help?
Do you have a question about the FOXBOX Tx VGA MM and is the answer not in the manual?
Questions and answers