Extron electronics FOXBOX Tx VGA MM User Manual page 43

Advanced Configuration panel
2 2 2 2 2 2 2 2 2 2
1 1 1 1 1 1 1 1 1 1
Figure 22. Advanced Tab
Link Mode buttons (see figure 22,
enable and disable link 2 (the return to the transmitter).
recommended when the transmitting device is a FOX 500 DA6 and the receiver is connect
to any of outputs 2 through 6 on the DA. These radio buttons are included in this guide for
completeness.
Executive Mode buttons (
the operation of the FOXBOX units.
Auto Memory checkbox (
apply saved position, horizontal start, total pixels, and pixel phase settings when the sensed
input resolution changes.
Auto Image button (
) — Click the
4
the best image, based on the sensed input resolution.
Test Patterns drop box (
5
, and
Grayscale Alternating Pixels
contrast, and focus of the display. Select
NOTE: You must have a video input connected and the transmitter-Tx-to-receiver-Rx
fiber cable connected and the receiver must be in the normal mode for the receiver to
output a selected test pattern.
The test pattern turns off if the input signal rate is changed or disconnected or if power
is removed.
3 3 3 3 3 3 3 3 3 3
5 5 5 5 5 5 5 5 5 5
4 4 4 4 4 4 4 4 4 4
) — The
1 Link Mode
) — The
2 Executive Mode
) — Click the
3 Auto Memory On
button to adjust the output settings for
Auto Image
) — Select one of three built-in test patterns;
; as necessary to help adjust the color, brightness/
to output the video input to the transmitter.
Off
FOXBOX Tx / Rx • Remote Control
radio buttons allow you to
is primarily used and
Disable
radio buttons have no effect on
radio button to automatically
Colorbars
,
35