System Compatibility - Extron electronics FOXBOX Tx VGA MM User Manual

System Compatibility

The FOXBOX Tx DVI Plus transmitter fiber optic output signal can be received only by a
FOXBOX Rx DVI Plus receiver.
All fiber optic signals from all other units are interchangeably compatible between VGA and
DVI units, Plus and non-Plus units, and PowerCage Fox and FOX 500 units as shown in the
following table.
Receiver
FOXBOX Rx VGA
FOXBOX Rx DVI Plus
FOXBOX Rx DVI (non Plus)
NOTES:
• The FOXBOX units are fully compatible with all Extron FOX 500 products and a
variety of other fiber optic products. Those other products are identified where
appropriate, but not specifically described in this manual.
• The FOXBOX DVI does not support the transmission of signals with High-bandwidth
Digital Content Protection (HDCP).
Compatible transmitters
FOXBOX Tx VGA
FOXBOX Tx VGA/YUV
FOXBOX Tx DVI (non-Plus)
PowerCage FOX Tx VGA
PowerCage FOX Tx DVI (non-Plus)
FOX 500 Tx (VGA)
FOX 500 Tx DVI
FOX 500 DA6
FOXBOX Tx DVI Plus
FOXBOX Tx DVI (non-Plus)
FOXBOX Tx VGA
FOXBOX Tx VGA/YUV
PowerCage FOX Tx DVI Plus
PowerCage FOX Tx DVI (non-Plus)
PowerCage FOX Tx VGA
FOX 500 Tx (VGA)
FOX 500 Tx DVI
FOX 500 DA6
FOXBOX Tx DVI (non-Plus)
FOXBOX Tx VGA
FOXBOX Tx VGA/YUV
PowerCage FOX Tx DVI (non-Plus)
PowerCage FOX Tx VGA
FOX 500 Tx (VGA)
FOX 500 Tx DVI
FOX 500 DA6
FOXBOX Tx / Rx • Introduction 4