Extron electronics FOXBOX Tx VGA MM User Manual page 35

Command and Response Table for SIS Commands (continued)
Command Function
Information requests
Information request
NOTE: The receiver monitors the primary (transmitter-TX to receiver-Rx) fiber cable. If the PC is connected to the transmitter and the
receiver-Tx-to-transmitter-Rx fiber cable is not connected, for the
the status of the primary cable.
Show firmware version
Example:
Request part number
Request part number of other unit
Show link 1 status
Show link 2 status
Show input video status
Show input audio status
Show temperature
Resets
Reset audio
Reset memory presets
System reset
X1(
NOTE: = Link and input status
X2)
= Transmission mode
X2!
= Transmitter or receiver
X2@
= Firmware version
X2#
= Internal temperature
SIS Command Response
(Host to Unit) (Unit to Host)
I 1Lnk X1(
I
and
X2@]
Q
Q 1
.
N 60-
1N 60-
X1(]
1S
X1(]
2S
X1(]
3S
X1(]
4S
X2#]
20S
E ZA } Zpa ]
E ZG } Zpg ]
E ZXXX } Zpx ]
0 = link or input not sensed 1 link or input sensed
= singlemode = multimode
SM MM
= transmitter = receiver
Tx Rx
v.vv
nnn •nn
F C
Additional description
2Lnk X1( RGB X1( Aud X1( X2)
• • • •
The unit responds with the current status
(signal detected) of optical link 1, optical
link 2, the video input, and the audio
link; the fiber optic transmission mode
(singlemode or multimode); and the
device type (Tx or Rx).
1S
commands, the transmitter reports
23 ]
The factory-installed firmware version is
1.23 (sample value only).
]
See www.extron.com.
nnn-nn
] See www.extron.com.
nnn-nn
Light status on transmitter-Tx-to-
receiver-Rx cable.
Light status on receiver-Tx-to-
transmitter-Rx cable.
Show transmitter video input status.
Show transmitter audio input status.
Show temperature in degrees Fahrenheit
and Celsius
Reset audio setting to default levels
(0 dB gain).
Reset (erase) all memory presets.
Reset all settings to factory defaults.
FOXBOX Tx / Rx • Remote Control
X2!]
•
1lnk0
regardless of
27