Table of Contents
Advertisement
40: 10 Operator Displays
Several displays are provided that enable the operator to perform manual
operations. The functions the operator can perform are listed in the General
Selection display. Each function has a single or multiple-character identification
associated with it. The operator selects the function to be performed by keying in
the associated identification. Certain functions have their own display associated
with them.
General Selection Display
COMMAND:
The General Selection display for operator use is shown in Figure 13. When CE
mode is in effect, additional functions that can be utilized only in CE mode are
listed as well. The General Selection display is automatically displayed when
manual mode operations are initiated and can be selected by pressing the mode
select key. This display can also be selected from other operator displays.
GENERAL SELECTION
y
TIME-OF-DAY ENABLE
F
CONFIGURATION/REMOTE
J
INTERVAL TIMER SWITCH
L
PROGRAM LOAD
s
STORE STATUS
A
COMPARE/TRACE
N SYSTEM RESET-NORMAL
K CHECK CONTROL
c
SYSTEM RESET-CLEAR
0
OPERATION RATE
R
RESTART
D DISPLAY/ ALTER
T
TARGET PU-SWITCH
B
BLOCK/PATCH
p
PROBLEM ANALYSIS
E
ERROR DISPLAYS
z
RETURN TO PROG SYS
Figure 13.
The General Selection display
The functions listed on the General Selection display are the same for System/370
and System/370-XA modes with one exception. When System/370-XA mode is
in effect, the interval timer function is not listed.
The operator displays provided for 4381 Processors are very similar to those
provided for 4341 Processors. For discussion of the contents and use of the
displays for 4381 Processors, see IBM 4381 Processor Operations Manual
90
A Guide to the IBM 4381 Processor
.....,
Advertisement
Table of Contents
