Idu-R Installation; Mounting The Idu-C; Figure 3-11 Typical Idu-E Rear Panel - Radwin WinLink 1000 Series User Manual

Mounting the IDU-C

Figure 3-11: Typical IDU-E Rear Panel

IDU-R Installation

Figure 3-12: IDU-R Rear Panel
Installation of an IDU-R unit differs from other IDU models in one respect:
At the rear of the IDU-R (see
"Trunks". For each IDU-R, the E1 cable from outside should be plugged into
one of the trunks, and the E1 cable to the other station should be plugged
into the second trunk, as in the left hand side of
Apart from the above difference, the link installation including the remaining
part of the IDU installation and connection to the ODU proceeds as
described as above.
Mounting the IDU-C
The WinLink™ 1000 IDU-Cs are all rack mountable, as shown in
13. A front panel keyed schematic of a rack mounted IDU-C is shown in the
figure below.
Figure 3-13: IDU-C front panel
In Figure 3-14
WinLink™ 1000 User Manual
Figure 3-12) there are two jacks labeled
we display a perspective view of the IDU-C:
Release 1.9
Chapter 3
Figure 1-14.
Figure 3-
3-10