Winlink™ 1000 Link; Figure 1-7 Example Of Link Architecture - System Components - Radwin WinLink 1000 Series User Manual

WinLink™ 1000 Link
»
»
»
»
WinLink™ 1000 Link
The WinLink™ 1000 point-to-point solution is a wireless communication link.
Typically each side of the link is comprised of an Outdoor Unit (ODU) and
antenna and an Indoor Unit (IDU) or PoE device as shown in
below.
The link is managed by the SNMP-based RADWIN Manager application.
The IDU and the ODU are connected by a CAT5e cable that carries the ser-
vice traffic and power.
Figure 1-7: Example of Link Architecture - System Components
WinLink™ 1000 User Manual
mutual interference commonly experienced with collocated TDD
radios.
Monitored Hot Standby (1+1):
The RADWIN Monitored Hot Standby supports equipment and air-
interface redundancy with less than 50 ms cut-over time for carriers
and operators.
Enhanced Air Interface Security
WinLink™ 1000's AES 128-bit key encryption provides enhanced air
interface security.
Advanced Management and Performance Monitoring
The WinLink™ 1000 Manager software has full local and remote
management capabilities. The user-friendly SNMP based manage-
ment tool provides full end to end configuration, event log, and per-
formance monitoring capabilities.
Multiple WinLink™ 1000 links can be managed by RADWIN Network
Management System (RNMS).
SFP support in the IDU-C
Standard SFP modules are used, enabling any type of Ethernet phys-
ical connectivity including various fiber connections. E3/T3 or E1/T1
over Ethernet SFPs can be used as well.
Release 1.9
Chapter 1
Figure 1-7
1-6