Brs Link Configuration - Radwin WinLink 1000 Series User Manual

BRS Link Configuration

BRS Link Configuration
The BRS link is reconfigured during the Link Installation or the Link Configu-
ration wizards, or from the Air Interface screen.
Both sites in a BRS Link must be configured identically.
Any changes to the frequency settings cause the link to re-
synchronize. A short loss of service will occur during re-
Note
synchronization.
To Configure BRS Channel Settings:
1. Set the Band Plan.
2. Select the Bandwidth required,
•
•
3. Select the Frequency from the pull-down menu.
4. Click Next. The system is re-synchronized to the changes.
Figure I-4: BRS Channel Settings Post-Transition
WinLink™ 1000 User Manual
Single Band
Double Band
Release 1.9
Appendix I
I-3