Changing The Link Password; Radwin Manager Community Strings; Editing Community Strings; Figure 8-7 Available Security Features - Radwin WinLink 1000 Series User Manual

Changing the Link Password

Figure 8-7: Available security features
Changing the Link Password
This item is only available when the link is down. Otherwise, it works the
same way as the corresponding item on

RADWIN Manager Community Strings

The ODU communicates with the RADWIN Manager using SNMPv1 protocol.
The protocol defines three types of communities:
•
•
•
The Community string must be entered at log on. The user must know the
password and the correct Community string to gain access to the system. A
user may have read-only privileges.
It is not possible to manage the ODU if the read-write or the read Commu-
nity values are forgotten. A new Community value may be obtained from
RADWIN Customer Support for the purpose of setting new Community. You
must also have available the serial number or the MAC address of the ODU.
The read-write Community strings and read-only Community strings have a
minimum of five alphanumeric characters. (bru1 and bru4097 are not per-
mitted). Changing the trap Community is optional and is done by clicking
the check box.

Editing Community Strings

The Community change dialog box is available from the Configuration |
Security tab. Both read-write and read-only communities must be defined.
On logging on for the first time, use the following as the current Commu-
nity:
WinLink™ 1000 User Manual
Read-Only for retrieving information from the ODU
Read-Write to configure and control the ODU
Trap used by the ODU to issue traps.
Release 1.9
page 5-7.
Chapter 8
8-8