Lan Port For Poe-8; Trunk Ports - E1/T1 Rj45 Connector; Hot Standby Port; Table O-3 Fast Ethernetc - Radwin WinLink 1000 Series User Manual

LAN Port for PoE-8

LAN Port for PoE-8
When connecting the PoE-8 LAN port cable directly to PC, a crossed
LAN cable, terminated with RJ-45 connectors on both ends must be
used, wired according to
O-PoE to PC LAN Cable
When connecting the O-PoE ETH port cable directly to a PC, a
crossed LAN CAT-5e, 4 twisted-pair 24 AWG STP, terminated with
RJ-45 connectors on both ends must be used. The pinout in
Table O-3

Trunk Ports - E1/T1 RJ45 Connector

The E1/T1 interfaces terminate in 8-pin RJ-45 connectors, as shown in
Table O-4
Hot Standby Port RJ-11
WinLink™ 1000 User Manual
Table O-2: Fast Ethernet Connector Pinout (Continued)
Function Signal
Receive Data (positive)
Receive Data (negative)
Table O-3:
Table O-3: Fast Ethernet Connector Pinout
Function Color
Ethernet (RxN) White/Green
Ethernet (RxT) Green
Ethernet (TxT) White/Orange
Ethernet (TxN) Orange
applies here.
below:
Table O-4: Trunk Ports - E1/T1 RJ45Pinout
Function Signal
Transmit Data Tip TxTip
Transmit Data Ring TxRing
Receive Data Tip RxTip
Receive Data Ring RxRing
Table O-5: Hot Standby RJ-11 Port Pinout
Signal Pin
HSB out 1
HSB in 2
Release 1.9
Pin
RD (+) 3
RD (–) 6
PC
3
6
1
2
Pin
1
2
4
5
Appendix O
O-2