Setting The Maximum Information Rate - Radwin WinLink 1000 Series User Manual

Setting the Maximum Information Rate

To configure the Ethernet Mode:
1. From the Configuration menu, choose the site to configure.
The Site Configuration dialog box opens.
2. Click Advanced | Ethernet.
3. In the Ethernet Ports Configuration pane, use the drop-down menu to
choose the configuration.
4. Click Apply to save the changes.
It is possible to close the Ethernet service by disconnecting the Ethernet
port.
If you close the port, you may subsequently be unable to access the
device. If this should occur, a workaround is as follows:
Note
•
•
•
Setting the Maximum Information Rate
The maximum Ethernet throughput of the link can be limited. The default
setting is
tion rate available for the link conditions and settings is used.
To limit the Ethernet information rate:
1. From the Configuration menu, choose the site to reconfigure.
2. Click Advanced | Ethernet
The Configuration dialog box opens.
WinLink™ 1000 User Manual
Connect the system from the remote site
Connect via other Ethernet port (of the IDU)
Power down the equipment and connect immediately after power
up (the fastest way is to enter install mode)
Best Effort
(see Figure 8-13
Release 1.9
above), where the highest informa-
Chapter 8
8-16