Laser Class - MICRO-EPSILON optoCONTROL 1202 Instruction Manual

2.
The optoCONTROL 1202 sensor operates with a semiconductor laser with a wavelength of 670 nm
(visible/red). The maximum optical output is ≤ 0.39 mW. The sensors are classified in Laser Class 1 (Class I).
The accessible radiation is harmless under predictable conditions.
The following warning labels are attached to the cover of the sensor housing:
Impairment of color vision and inconvenience may not excluded for class 1 laser devices, e. g. through glare.
Consequently, you can use Class 1 laser equipment without further protective measures.
Class 1 lasers are not subject to registration and a laser protection officer is not required.
The laser warning label for Germany is included in delivery. The version applicable to the user's country must
be applied before the equipment is used for the first time.
i
If both information
labels are hidden in
the installed state, the
user must ensure that
additional labels are
fitted at the point of
installation.
Fig. 1 True reproduction of the sensor with its actual location of the warning labels, view on top side
optoCONTROL 1202

Laser Class

Class 1 Laser Product
IEC 60825-1: 2008-05
IEC label
The housing of the transmitter and receiver may only be opened by the manufacturer! For repair and
service purposes the sensors must always be sent to the manufacturer!
Receiver
THIS PRODUCT COMPLIES
WITH FDA REGULATIONS
21CFR 1040.10 AND 1040.11
Only for USA
Laser beam
Class 1 Laser Product
IEC 60825-1: 2008-05
Transmitter
THIS PRODUCT COMPLIES
WITH FDA REGULATIONS
21CFR 1040.10 AND 1040.11
Page 8