Mircom Flex-Net Phase II Application Manual page 105

Line 1
• Dial Using
• Wait
Line 2
• Dial Using
• Wait
Report Priority
• Alarm
• Supv
• Trouble
Timers
• AC loss delay
• Line 2 Cellular Test
• Auto test at
Dialer
• Line Retries
• Rings
• Mode
• Enable
104
• Tone/Pulse
• Check to wait for dial tone before dialling
• Tone/Pulse
• Check to wait for dial tone before dialling
• Choose one of the two accounts to use to report Alarms
• Choose one of the two accounts to use to report Supvisory alerts
• Choose one of the two accounts to use to report Troubles
• 0-20 hours
• Check this box to indicate that Line 2 dials a cell phone. Use the Spin box to
specify the day of the month (1 - 28) for the cell phone test.
• Use this spin box to set the time for a daily test of land lines.
• Use this Spin Box to specify the number of retries to make (5-10)
• Use this Spin box to specify the number of rings when dialing in to configure.
Warning: if set to zero the next dial in session will not be able to connect.
• Choose between DACT and UDACT
• Uncheck this box if you wish to set the dialer to the disabled state when you
send the job to the panel. If you receive a job from the panel when the dialer
was temporarily disabled then this check box will be un-checked. The dialer is
enabled by default.
Appendix B: Using the Configurator