Gas Medium Supervision Ssimg; Identification; Application; Setting Guidelines - ABB RELION 650 Series Applications Manual

1MRK 504 158-UEN A
Table 31:
Setting
Operation
PowAmpFact
PowAngComp
Mode
k
UGenZeroDb
IGenZeroDb
UBase (set in
Global base)
IBase (set in
Global base)
13.2

Gas medium supervision SSIMG

13.2.1

Identification

Function description
Gas medium supervision
13.2.2

Application

Gas medium supervision (SSIMG) is used for monitoring the circuit breaker condition. Proper
arc extinction by the compressed gas in the circuit breaker is very important. When the
pressure becomes too low compared to the required value, the circuit breaker operation shall
be blocked to minimize the risk of internal failure. Binary information based on the gas
pressure in the circuit breaker is used as an input signal to the function. The function
generates alarms based on the received information.
13.2.3

Setting guidelines

The parameters for the gas medium supervision SSIMG are set via the local HMI or PCM600.
Operation : Off/On
•
PresAlmLimit : Alarm setting pressure limit for gas medium supervision
•
PresLOLimit : Pressure lockout setting limit for gas medium supervision
•
TempAlarmLimit : Temperature alarm level setting of the gas medium
•
Application manual
General settings parameters for the Measurement function
Short description
Operation Off / On
Amplitude factor to scale
power calculations
Angle compensation for phase
shift between measured I & U
Selection of measured current
and voltage
Low pass filter coefficient for
power measurement, U and I
Zero point clamping in % of
Ubase
Zero point clamping in % of
Ibase
Base setting for voltage level
in kV
Base setting for current level
in A
Selected Comment
value
On Function must be
1.000 Typically no scaling is required
180.0 Typically no angle compensation is required.
However here the required direction of P & Q
measurement is towards busbar (Not per IED
internal default direction). Therefore angle
compensation have to be used in order to get
measurements in aliment with the required
direction.
L1L2 Only UL1L2 phase-to-phase voltage is
available
0.00 Typically no additional filtering is required
25 Set minimum voltage level to 25%
3 Set minimum current level to 3%
35.00 Set LV side rated phase-to-phase voltage
495 Set transformer LV winding rated current
IEC 61850 IEC 60617
identification identification
SSIMG -
Section 13
Monitoring
On
GUID-358AD8F8-AE06-4AEA-9969-46E5299D5B4B v3
GUID-AD96C26E-C3E5-4B21-9ED6-12E540954AC3 v3
ANSI/IEEE C37.2
device number
63
GUID-A840E38C-CC42-4995-A569-A6092DDB81B2 v5
GUID-DF6BEC98-F806-41CE-8C29-BEE9C88FC1FD v1
207