Emerson Micro Motion 4200 Configuration And Use Manual page 92

Configure device options and preferences
April 2019
Table 7-2: Options for alerts and conditions
Alert
Event Active
• Default severity: Out of
Specification
• Severity configurable: Yes
• Fault Timeout applicable: Yes
Output Saturated
• Default severity: Out of
Specification
• Severity configurable: Yes
• Fault Timeout applicable: No
Function Check Failed or Meter
Verification Aborted
• Default severity: Maintenance
Required
• Severity configurable: Yes
• Fault Timeout applicable: No
Configuration Warning
• Default severity: Maintenance
Required
• Severity configurable: Yes
• Fault Timeout applicable: No
92
(continued)
Name
Moderate Two-Phase Flow
Severe Two-Phase Flow
Enhanced Event 1 Active
Enhanced Event 2 Active
Enhanced Event 2 Active
Enhanced Event 3 Active
Enhanced Event 4 Active
Enhanced Event 5 Active
[100] mA Output 1 Saturated
[113] mA Output 2 Saturated
[110] Frequency Output 1
Saturated
[010] Calibration Failed
[034] Meter Verification
Failed
[035] Meter Verification
Aborted
No Permanent License
Clock Failure
Transmitter Software Update
Failed
Configuration and Use Manual
Conditions
Description
The transmitter has detected
moderate two-phase flow.
The transmitter has detected severe
two-phase flow.
The conditions assigned to
Enhanced Event 1 are present.
The conditions assigned to
Enhanced Event 1 are present.
The conditions assigned to
Enhanced Event 2 are present.
The conditions assigned to
Enhanced Event 3 are present.
The conditions assigned to
Enhanced Event 4 are present.
The conditions assigned to
Enhanced Event 5 are present.
The calculated output value is
outside the range of the output.
The calculated output value is
outside the range of the output.
The calculated output value is
outside the range of the output.
The calibration failed.
The meter verification test showed
that the sensor response was not
acceptably close to the baseline.
The meter verification test did not
complete, possibly because it was
manually aborted or because
process conditions were too
unstable.
A permanent license has not been
installed in the transmitter firmware.
The transmitter's real-time clock is
not incrementing.
The transmitter software update
failed.
Micro Motion 4200 Transmitters
MMI-20048166
Ignorable
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Yes
Yes
No
No
Yes