Configuration and Use Manual
MMI-20048166
Postrequisites
If you disabled LD Optimization before the calibration procedure, re-enable it.
12.6.3 Perform a D1 and D2 density calibration using the Field
Communicator
Procedure
1. Read the Prerequisites in
done so.
2. See the following figure.
Postrequisites
If you disabled LD Optimization before the calibration procedure, re-enable it.
Configuration and Use Manual
Perform a (standard) D1 and D2 density calibration
Measurement support
April 2019
if you have not already
143