Emerson Micro Motion 4200 Configuration And Use Manual page 82

Configure device options and preferences
April 2019
Table 7-1: Default configuration for display variables
Display variable
Display Variable 1
Display Variable 2
Display Variable 3
Display Variable 4
Display Variable 5
Display Variable 6
Display Variable 7
Display Variable 8
Display Variable 9
Display Variable 10
Display Variable 11
Display Variable 12
Display Variable 13
Display Variable 14
Display Variable 15
7.1.3 Configure the number of decimal places (precision) shown on
the display
Menu > Configuration > Display Settings > Decimals on Display
Display
ProLink III Device Tools > Configuration > Transmitter Display > Display Variables > Decimal Places for x
Field Communicator Configure > Manual Setup > Display > Decimal Places
You can specify the precision (the number of decimal places) that the display uses for each display variable.
You can set the precision independently for each display variable.
The display precision does not affect the actual value of the variable, the value used in calculations, or the
value reported via outputs or digital communications.
Procedure
1. Select a process variable or a diagnostic variable.
You can configure the precision for all variables, whether or not they are assigned as display variables.
The configured precision will be stored and used when applicable.
2. Set Number of Decimal Places to the number of decimal places to be used when this variable is shown
on the display.
• Default:
— Temperature variables: 2
— All other variables: 4
82
Process variable assignment
Mass flow rate
Mass total
Volume flow rate
Volume total
Density
Temperature
Drive gain
None
None
None
None
None
None
None
None
Configuration and Use Manual
MMI-20048166
Micro Motion 4200 Transmitters