Changing The Device Settings And Alarms - PHILIPS Respironics Trilogy 100 Clinical Manual

Changing the Device Settings and Alarms

From the Main Menu screen, use the Up/Down button to highlight
the Settings and Alarms menu, and press the Right button to select
the menu.
Device Settings
Some of the settings on this menu will vary depending on the
therapy mode you select. The section below describes all of the
settings that are common to all therapy modes. Refer to the Therapy
Modes Table in Chapter 3 for settings that are specific to each mode.
Dual Prescription Setting
You can turn the dual prescription setting on or off. Enable the
setting if you want to create two separate prescriptions for the
patient. For instance, you may want to set up a daytime prescription
and then a separate nighttime prescription. If you enable this setting,
then the menu options on the Main Menu will change to include
three new options:
•
Switch to Primary/Secondary Settings
•
Primary Settings and Alarms
•
Secondary Settings and Alarms
The Main Menu screen will look like the screen below.
Note: In the Options menu
described later in this chapter,
you can specify the Pressure
Units displayed by the device,
choosing either cm H
or mBar. The default setting is
cm H O, so this manual uses
2
cm H O throughout.
2
Main Menu Screen with Dual
Prescription Enabled
Chapter 5 Viewing and Changing Settings
69
O, hPa,
2