Hysteresis; Operating Parameters; Output Modules - Ahlborn ALMEMO 5690-2M Operating Instructions Manual

Enter atm. pressure in the Atm pressure function

12.5.7 Hysteresis

The hysteresis for an alarm triggered in the event of a limit value being ex-
ceeded can be set generally for all sensors from 0 to 99 digits (default 10 digits)
in the Hysteresis function (see 12.3.5 and Manual 6.2.7).
To modify hysteresis (0 to 99) (see 10.5)

12.5.8 Operating parameters

Certain operating parameters can be configured by the user as software options
in the function Configuration (see Manual 6.10.13.2).
Change mains frequency noise suppression from 50Hz to 60Hz
To delete all measured values at the start of a meas. op.
Ring memory (values are overwritten if memory full)
Immediate output via the interface, oversampling
Switch signal transmitter off
The following parameters can be used to check proper device functioning :
Of 60 possible channels 25 are activated :
Sensor supply voltage 11.7 V = mains operation
Cold junction temperature = socket temperature :

12.6 Output modules

Data logger ALMEMO
put sockets A1 and A2; these can output mea-
sured values in either analog or digital form or
as an alarm signal. It is also possible to initi-
ate various functions by means of trigger
pulses. To cover all possibilities while also
keeping the hardware to a minimum all neces-
sary interfaces have been integrated on the
ALMEMO output connectors.
®
These output modules, just like the sensors,
are automatically recognized and shown in
the
OUTPUT MODULES
With the relay trigger modules (in particular
module ES5690-RTA5) certain function variants can be configured (see
12.6.2), relays can have certain limit values assigned to them (see 7.5), or
analog outputs can be assigned to certain measuring channels. In this menu
all ports can be selected and configured accordingly. The connection possibili-
ties are described in the instructions for the output module concerned.
5690-2M has two out-
®
menu.
Device configuration
Atm pressure: 1013 mbar
Hysteresis :
Configuration:F-------
Configuration:-C------
Configuration:--R-----
Configuration:----A---
Configuration:-----S--
Measuring channels:60 active : 25
Sensor voltage :11.7 V
CJTemperature :25.4°C
* OUTPUT MODULES
±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±
Output socket A1:
DK Data cable
0: RS232
Baudrate:
Output socket A2:
EA Trigger-Alarm
2: Rx int. assigned
Relay: 01------
Analogue channel:
Analogue value:
ALMEMO
10
*
57.6 kBd
00
+32500
PRINT ESC
® 5690-2M 77