Table of Contents
Advertisement
10. Display and keypad
10.2 Status symbols in the display and status LEDs
Checking the device status
Continuous measuring point scan
Measuring stopped or started
Measuring point scan started with data saving
Measuring point scan started with output to interface
Start time or end time of meas. operation programmed
Status of relay (external output module) off / on
Keypad operation restricted by locking
Display backlighting switched on or pause
Battery charge status: full, half, empty
Symbols indicating the measured value status (see above)
No sensor, measuring point deactivated
Measured value modified with sensor correction or scaling
Averaging in progress
Output function Diff, Hi, Lo, M(t), Alarm (see 12.4.5):
Compensation C: T Temp., P Press. (atm.), . Continuous CT. P. (.
Limit value exceeded, maximum or minimum
Outside of measuring range : Maximum value
Outside of measuring range : Minimum value
Sensor breakage / voltage low : Display ´-.-.-´
10.3 Function keys
The function of keys
ferent in each of the various menus. The
function is indicated as an abbreviation in the
bottom line of the display (soft keys). In the
instructions and documentation these soft key
abbreviations are shown in angle brackets,
e.g.
.
<START>
Various status symbols are displayed next to
the measured value; (see below).
In the
standard display
lowing keys are available.
Measuring point selection using the cursor keys (3) (M in middle)
Start a cyclic measuring operation
Stop a cyclic measuring operation
Once-only manual output / saving of all measured values
Output menu functions via the interface
Return to menu selection
28
ALMEMO
to
(3) can be dif-
F1
F4
(on the right) the fol-
®
5690-2M
Status bar LEDs
C
ll
©
or
RECREC
COM
l©
or
©l
R--
R01
or
LOCKED
*
or
*
´´´´´´´´¶ , ´´´´´µµµµ¶ , ´µµµµµµµµ¶
´ ----- ´
º
»
AVG
D , H , L , M , A
flashes
▲ or ▼ flashes
O flashes ALARM
U flashes
B / L
flashes ALARM
C © REC COM l© ©l R01 * ´´´´´´µµµµ¶
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
01:
Velocity
æ
28.67
Maximum value:
Minimum value:
Cycle-timer:
00:02:30 Un
Memory free:
START MANU M PRINT ESC
F1
F2
|
o.
<START>
<STOP>
<MANU>
<PRINT>
< ESC
>
START
COM
)
ALARM
m/s
» H º
31.34 mls
25.37 mls
512.0 kB
F3
F4
...
or
F1
or
F1
or
F2
or
F3
or
F4
Advertisement
Table of Contents
