Table of Contents
Advertisement
12. Programming using the programming menus
12.6.1 Data cables
Via the serial interface you can output cyclic data logs, all the function values
from the measuring menus, and all the programming details for the device and
for the sensors to a printer or computer. The ALMEMO
connection to devices are described in detail in the Manual, Section 5.2. Other
modules for networking the devices are described in detail in the Manual, Sec-
tion 5.3. All available interface modules can be connected to socket A1 (2); this
is with the exception of cable ZA 1999-NK, which is used for networking extra
devices; this must be connected to socket A2.
In the menu under the socket concerned the following information is displayed :
Output socket A1:
Variant 0 : Serial standard interface always active
The baud rate is saved in the cable connector :
12.6.2 relay trigger analog modules
Whereas, for the purposes of addressing peripheral
devices for relay and trigger input (see Manual
5.1.2/3), V5 modules (ZA1000-EAK) provide only
one function variant (see Manual XREF), the new
V6 relay trigger output modules, e.g. module
ES5690-RTA5 (see XREF), offer up to 10 elements.
Relays, trigger inputs, or analog outputs can be indi-
vidually configured regarding their function variant.
These external modules can be connected equally
well to either output socket A2 or A1 (2); the module
is located on the bus. To ensure that all elements
can be addressed, each of these sockets has been
assigned 10 port addresses..
Socket
Connection
A1
A2
B3 to 9
99
In the Output modules menu the elements of the output modules can be indi-
vidually selected and functions programmed as follows : (see Manual, 6.10.9) :
First select the port by pressing :
e.g. Port 0, module B3 (port address 30):
The element concerned is recognized :
Relay :
Relay type = NO (normally open) :
Relay type = NC (normally closed) :
Relay type = changeover:
The relay switching mode can be configured to the following variants;see 10.5:
78
ALMEMO
V6 output modules to socket A1
V6 output modules to socket A2
Maximum seven ES5690-RTA5 modules on the bus
®
5690-2M
®
data cables and their
DK Data cable
0: RS232
Baud rate: 9600 baud
*
OUTPUT MODULES
±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±
Socket: A3
ES 5690RTA5
port: 0
Relais: NO 0.5A
8: Relais driven ext.
Status: active closed
Watchdog
Ø
ON
OFF
P PRINT ESC
Port addresses
10 to 19
20 to 29
or
<P>
:
▲
Port: 30
Relay : NO
Relay : NC
Relay : Changeover
*
Adr.: 30
30
to
▼
Advertisement
Table of Contents
