Print Cycle Factor; Minimum Sensor Power Supply - Ahlborn ALMEMO 5690-2M Operating Instructions Manual

Data acquisition system

Hide thumbs Also See for ALMEMO 5690-2M:

Table of Contents

Special functions

12.4.1 Print cycle factor

To adapt data recording to the speed of modification at individual measuring

points a print cycle factor can be programmed to between 00 and 99; this will

cause certain measuring points to be output less frequently or not at all (see

Manual 6.10.6). This print cycle factor is by default completely disabled or set to

01 for all measuring points; i.e. all activated measuring points are output in each

cycle. If some other factor e.g. 10 is entered the measuring point in question will

only be output every 10th cycle; if 00 is entered it will not be output at all. With

data saving similarly it is possible to suppress measured values that are unnec-

essary and thus save on memory capacity.

Print cycle factor : 01

Enter print cycle factor (see 10.5) in function:

To clear the print cycle factor press

<CLR>

As with all ALMEMO

devices the sensor supply voltage on the 5690-2M is

monitored. The sensor supply voltage is displayed in the Power supply menu

(see 12.7). Some sensors, to operate properly, need their own supply voltage

and this must be provided by a rechargeable battery or via a mains unit. To pre-

vent measuring errors the minimum sensor voltage needed by each individual

sensor can be entered in the Special functions menu . If the voltage drops

below this value the measured value will be treated as a sensor breakage (dis-

play ´L´ flashes) .

To enter the minimum sensor supply voltage :

Sensor voltage, minimum :

12.0 V

To disable voltage monitoring, to delete the value :

<CLR>

Sensor voltage, minimum : ---- V

ALMEMO

5690-2M

Table of Contents