Hysteresis; Operating Parameters - Ahlborn ALMEMO 2590-2A Operating Instructions Manual

14.7 Hysteresis

The hysteresis for an alarm triggered in the event of a limit value being exceeded
can be set generally for all sensors from 0 to 99 digits (default 10 digits) in the
Hysteresis function (see 13.5 and Manual 6.2.7).
To modify hysteresis (0 ... 99) see 9.5:

14.8 Operating parameters

Certain operating parameters can be configured by the user as software options
in the function; (see Manual 6.10.13.2).
Change mains frequency noise suppression from 50Hz to 60Hz
To delete all meas. values at the start of a measuring operation
Ring memory
Immediate output via the interface, oversampling
Switch signal transmitter off
To program the configuration press :
To select parameters press :
To enable / disable parameters press :
Hysteresis :
PROG
14. Device configuration
Configuration: F-------
Configuration: -C------
Configuration: --R-----
Configuration: ----A---
Configuration: -----S--
-C------
Configuration:
or
► ◄
or
▲ ▼
10
67