Connecting Peripheral Equipment; Putting Into Service; Technical Data - Ahlborn ALMEMO 5690-2M Operating Instructions Manual

9. Relay trigger analog module
case be programmed as standard output 0 to 10 V, 0 to 20 mA, 4 to 20 mA for
any partial measuring ranges. (see 12.4.4, 12.6.3)

9.2.4 Connecting peripheral equipment

Peripherals can be connected via the supplied ALMEMO
cording to the following arrangements.
P0/1
Terminals Relay
y1 R1 n. closed (opt.) R3 n. closed (opt.)
y2 R1 Common
y3 R1 n. open (opt.)
x3 R0 n. open (opt.)
x2 R0 Common
x1 R0 n. closed (opt.) R2 n. closed (opt.)

9.2.5 Putting into service

1.The relay module should be plugged into a free slot in the ALMEMO
the integrated interface elements are then available as port P30 to P39.
2. The peripheral equipment should be connected to the clamp connector and
plugged in on the relay module at the appropriate port sockets. see 9.2.4
4.All the programming functions can be performed via the device keypad in the
"Output modules" menu (see 12.6.2) or using the AMR-Control software or via
terminal commands. (see Manual, 6.10.9.2 and 6.10.10)

9.3 Technical data

Relays
Trigger inputs
Analog outputs electrically isolated, optionally
OA 8006-R02 0.00 to +10.0 V, 0.5 mV / digit, Load >100 kΩ
Accuracy
Temperature drift
Time constant 100 µs
Power supply
Current consumption Standard approx. 10 to 20 mA
Housing
26 ALMEMO
P2/3
Relay
R3 Common
R3 n. open (opt.)
R2 n. open (opt.)
R2 Common
Semiconductor relay 1 ohm, Load capacity 50V, 0.5A
Optocoupler 4 to 30 V, Input current 2 mA
0.0 to +20.0 mA, 1 µA / digit, Load <500 Ω
±0.1% of final value
10 ppm / K
9 to 12 VDC from the measuring instrument
For each 2 analog outputs appr. 15 mA + 1.75 x I
19" plug-in device 8 DU
® 5690-2M
® screw connectors ac-
P4/5 P6/7
Analog (opt.) Analog (opt.)
(opt.) (opt.)
AO5 + AO7 +
AO5 - AO7 -
AO4 - AO6 -
AO4 + AO6 +
P8/9
Trigger
U+
TR9+
TR9 -
TR8 -
TR8+
U -
system;
®
OUT