Videx 4000 Series Technical Manual page 65

4000 Series GSM Audio Intercom with Proximity
System Operation
OPERATION WHEN CONNECTED TO THE GSM PRO INTERCOM VIA RS485
When the Art.4903 codelock is connected to the GSM PRO intercom via the RS485 terminals it can operate with additional access
control features (refer to the notes and Fig.16 on page 16, to the notes and Fig.41 on pages 27 - 29, and also programming features
in the programming section of this manual).
CORRECT CODE ENTERED (ACCESS GRANTED)
To operate:
1. Enter the access code for the respective relay followed by the
ENTER button;
2. The green data LED (Fig.104,
red busy LED (Fig.104,
after the other;
3. The green data LED (Fig.104,
the appropriate relay (RLY1 or RLY2 depending on setup) will
activate and keypad will emit a series of 1 second interval
beeps for the duration of the programmed relay time.
If the speechboard is switched ON then the GSM PRO will
announce "the gate is open" or "the door is open".
INCORRECT CODE ENTERED (ACCESS DENIED)
If an incorrect access code is entered:
1. The green data LED on the Art.4903 and the red busy LED on
the GSM PRO will flash one after the other;
2. Both the LED's on the keypad will switch ON (Fig.105,
green data LED will then switch OFF (Fig.105,
by the red status LED and the codelock will play a melody
3
(Fig.105, );
3. No relay will activate.
If the speechboard is switched ON then the GSM PRO will
announce "invalid code".
IMPORTANT NOTE: If an Art.4903 keypad is connected via RS485 to the GSM PRO module and setup as device ID.1 only then
will the speech annunciation come through the GSM's speaker i.e. "the gate is open" etc. (provided that the speechboard is also
switched ON) when an access code is entered on the keypad.
4000 Series GSM Audio Intercom - Technical Manual
1
) on the Art.4903 and the
2
) on the GSM PRO will flash one
3
) will then flash once and
2
), followed
Art.4903 status LED's
1
3
Fig. 104
1
1
). The
3
Fig. 105
- 65 -
GSM PRO status LED's
2
3 secs...
Art.4903 status LED's
2
66250754-EN - V1.0 - 18/02/19