Address Ids For The Modules In An Et 200U(Dp Siemens) - Siemens SIMATIC S5 ET 200U Manual

ET 200U(DP Siemens): AddressAssignment,Starting–Up,Diagnosing Faults Using COMET200
Table 4-2

Address IDs for the Modules in an ET 200U(DP Siemens)

Order Num- Address ID
ber of Module ET 200U
(DP Siemens)
Analog Inputs 6ES5 ...:
1
464–8MA11 1–channel:
1
464–8MA21 1AI or 012,
1
464–8MB11 2–channel:
1
464–8MC11 2AI or 013,
1
464–8MD11 4–channel:
1
464–8ME11 4AI or 015
2
464–8MF11 1–channel:
1AI or 012,
2
464–8MF21 2–channel:
2AI or 013
466–8MC11 2AI or 013
2
467–8EE11 1–channel:
1AI or 012,
2–channel:
2AI or 013
Analog Outputs 6ES5 ...:
470–8MA11 2AQ or 021
470–8MA12 2AQ or 021
470–8MB11 2AQ or 021
470–8MB12 2AQ or 021
470–8MC11 2AQ or 021
470–8MC12 2AQ or 021
470–8MD11 2AQ or 021
470–8MD12 2AQ or 021
470–8MD21 2AQ or 021
477–8EC11 2AX or 029
* The address scope is necessary for the inputs and the outputs (i.e. if the address scope is 2 bytes, 2 bytes are used
for the inputs and 2 bytes are used for the outputs). Since COM ET 200 assigns the addresses for these modules
optionally, inputs and outputs can have different start addresses.
1 With these analog modules, you can use one, two, or four channels.
2 With these analog modules, you can use one or two channels.
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
Address Delay Address
Scope Time Area
1
(Byte) (ms)
1–ch.: 1–channel: Analog
2 60
2–ch.: 2–channel:
4 120
4–ch.: 4–channel:
8 240
1–ch: 1–channel: Analog
2 60
2–ch.: 2–channel: Analog
4 120
4 20 Analog
1–ch.: 1–channel: Analog
2
2–ch.: 2–channel:
4
4 0.1 Analog
4 0.15 Analog
4 0.1 Analog
4 0.15 Analog
4 0.1 Analog
4 0.15 Analog
4 0.1 Analog
4 0.15 Analog
4 Analog
4* Analog
Current Power
Consump- Loss
tion (mA) (W)
70 0.7
100 0.7
70 0.7
70 0.7
70 0.7
70 0.7 to 1
g 70 0.9
g 100 0.9
100 0.9
320 0.7 to 3
3.1
3.1
3.8
3.8
3.8
3.8
3.1
3.1
350 3.2
4-11