Table of Contents
Advertisement
ET 200U(DP Standard): AddressAssignm.,Starting–Up, DiagnosingFaultsUsing COM ET 200
Configuring
The numbers above the input fields in the "Configuration" field designate the
slots of the ET 200U (DP Standard) slave station.
1. Assign a proper address ID to each module in the ET 200U(DP Standard)
Note
Please refer to Section 3.1 for the numbering of slots in case of a multi–tier
configuration.
If you are using page addressing, note the following:
With page addressing, peripheral byte 255 is assigned for selecting the page.
DP Standard Ad-
You can use more than one alternative to enter the address ID of an
dress ID
ET 200U(DP Standard) station:
Note
ET 200U(DP Standard) and ET 200U(DP Siemens) use different decimal
address IDs.
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
station (see following tables). Assign the slots in ascending order. Do not
skip any slot. If you have a slot that you are not going to use, enter "000"
as the address for that slot.
as decimal number (according to the PROFIBUS–DP draft standard)
or
as module code, e.g. 8DE or 1AE. COM ET 200 automatically converts
the module code into a decimal number
or
press <F7> (HELP) to obtain a list of all available I/O modules with ad-
dress ID. You can then select the required ID (first position the cursor in
the address ID input field).
5-9
Advertisement
Table of Contents
