How To Set The Profibus-Dp Address At Terminal Block M12, 7/8 - Siemens SIMATIC ET 200eco Manual

How to set the PROFIBUS-DP address at the terminal block M12, 7/8"
The permitted PROFIBUS-DP address range is 1 to 99.
1. Remove both lock caps on the rotary selector switches (use the 14–mm socket
wrench if need be).
2. Using the screwdriver, set the required PROFIBUS address on the selector
switches.
– Lower selector switch: one's place
– Upper selector switch: ten's place
3. Screw the two caps onto the selector switches again (Torque : 0.5 to 0.8 N/m).
Figure 2-4
ET 200eco Distributed I/O Station
A5E00158716-02
x10
x1

How to set the PROFIBUS-DP address at terminal block M12, 7/8"

Example PROFIBUS address 92:
x10
Position 9
x1
Position 2
Rotary selector
switch for setting
the PROFIBUS
address
Installation
2-7