Table of Contents
Advertisement
INDIVIDUAL DIAGNOSTICS screen
ET 200U(DP Siemens), 4-28
ET 200U(DP Standard), 5-31
Inherently short–circuit proof, B-3
Initiate, 6-11
Input, "Input" object, 6-14–6-18
Input module, connecting, 3-17
Input modules, connecting, 3-19
Input/output module, connecting, 3-21
Installing, 3-2, 3-3
Insulation monitoring, B-3
Interface modules, 8-14
interface module IM 315, 8-14
interface module IM 316, 8-15
technical specifications, 8-14, 8-15
Interference immunity, 3-9
IP 20, 1-3, B-4
IP 263 positioning module, technical specifica-
tions, 9-48
IP 265 high speed sub control, technical speci-
fications, 9-55
IP 266 positioning module, 9-58
analog output, 9-58
installation, 9-62
operating modes, 9-60, 9-62
operation principle, 9-60
positioning, 9-61
pulse input, 9-58
technical specifications, 9-58
IP 267 stepper motor control module, 9-63
installation, 9-65
LEDs, 9-65
operation principle, 9-64
technical specifications, 9-63
Isolated, B-4
K
KBL. See List of communication links
KR. See Communication reference
ET 200 Distributed I/O Station
EWA 4NEB 812 6087–02b
L
LED
"BUS FAULT", 2-2
"IM FAULT", 2-2
"RUN", 2-2
Length, B-4
Link attribute, 6-33
List of communication links, 6-30–6-36, B-4
Load power supply, 3-23, B-4
Local LSAP, 6-33
Loop resistance, B-4
M
Manufacturer identification, 4-33, 5-36
ET 200U(DP Siemens), 4-33
ET 200U(DP Standard), 5-36
ET 200U(DP Standard/FMS), 6-21
Master interface module, B-4
Master–slave access method, B-4
Max. PDU Size, 6-34
Modes of the IM 318–C, 6-2
Modifying an already configured slave station
ET 200U(DP Standard), 5-19
ET 200U(DPSiemens), 4-16
Modifying the configuration at a later point
ET 200U(DP Siemens), 4-15–4-17
ET 200U(DP Standard), 5-18–5-20
Module, comparator, 9-2
Module address
ET 200U(DP Siemens), 4-14
ET 200U(DP Standard), 5-14
Module diagnostics, 4-35, 4-36, 5-38, 5-39
"Module diagnostics" header, ET 200U(DP
Standard/FMS), 6-23
ET 200U(DP Siemens), 4-35, 5-38
ET 200U(DP Standard/FMS), 6-23, 6-24
Index
Index-7
Advertisement
Table of Contents
