Address Ids For The Modules In An Et 200U(Dp Standard) - Siemens SIMATIC S5 ET 200U Manual

ET 200U(DP Standard): AddressAssignm.,Starting–Up, DiagnosingFaultsUsing COM ET 200
Table 5-5

Address IDs for the Modules in an ET 200U(DP Standard)

Order No. of
Address ID
Module ET 200U(DP Standard)
Order Code
IP 264 Electronic Cam Controller:
1
264–8MA11 4AX/000
High Speed Sub Control IP 265:
265–8MA01 4AX
CP 521 BASIC:
521–8MB11 4AX
CP 521 SI:
521–8MA21 4AX
330–8MA11
or no module 000
plugged in
* The address scope is necessary for the inputs and the outputs (i.e. if the address scope is 2 bytes, 2 bytes are used
for the inputs and 2 bytes are used for the outputs). Since COM ET200 assigns the addresses for these modules
optionally, inputs and outputs can have different start addresses.
1 The module occupies 2 slots.
2 IP 265 can be operated in Slow Mode only. The Slow Mode must be set in the parameterization frame. Please refer
to Figure KEIN MERKER for the Slow Mode setting.
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
Address
Scope
(Byte) (Byte)
Decimal No.
243/000 8*
2
243 8*
243 8*
243 8*
000 0
Delay Ad- Current
Time dress Con-
1 1
(ms) (ms) Area Area sumption sumption
(mA)
Analog 120
Analog
Analog 180
Analog 140
0
Power
Loss
(W) (W)
4
1.6
1.2
5-13