Connecting A Lamp To Channel; Connecting Eight–Channel Output Modules - Siemens SIMATIC S5 ET 200U Manual

Mechanical and Electrical Configuration
Connecting Eight–
When connecting eight–channel output modules, you must connect actuators
Channel Output to terminal 2 of the terminal block via the M terminal strip. This situation
Modules
does not apply to the 8
ure 3–15 illustrates the following example for connecting a lamp to an eight–
channel output module:
Example
A lamp is connected to an eight–channel output module with start address
5.0. The lamp is connected to channel 6 (address Q 5.6).
Figure 3-16 Connecting a Lamp to Channel 6
3-20
5 to 24 V DC/0.1 A digital output module. Fig-
Channel 0
Channel 6
Channel 1
1 3 5 7
2 4 6
L+ M
M Terminal Strip
ET 200U Distributed I/O Station
9
8 10
Lamp
EWA 4NEB 812 6087–02b