Siemens SIMATIC S5 ET 200U Manual page 5

Distributed i/o statio
Table of Contents

Advertisement

"318–8MC11"
An interface for SINEC L2–DP (DP Standard) and SINEC L2–FMS is inte-
grated in the "318–8MC11".
The "318–8MC11" can be addressed via the same bus both with the DP Stan-
dard and FMS protocols.
Note
An "318–8MC11" can be operated as DP Standard slave in conjunction with
A "318–8MC11" module can be operated as an FMS slave on any bus type
conforming to the PROFIBUS DIN 19245 standard, Parts 1 and 2.
If the DP and FMS protocols are used on the bus at the same time, a maxi-
mum of two DP masters, one FMS master (additional active station) and one
programmer are permitted.
Notes for Conver-
In the following table, the differences between the 6ES5 318–8MB12 and the
sion from "8MB11"
6ES5 318–8MB11 modules are listed.
to "8MB12"
Table 1-1
Differences between the IM 318–B slave interface modules
Pulling and plugging–in of I/O modules under load voltage is only
permitted under defined conditions.
Depending on whether the "DP Siemens" or the "DP Standard" proto-
col is used, COM ET 200 requires different address identifiers for the
modules.
Different functions of switch 8 (SLOW mode).
Different behaviour when exiting from the SYSTEM START–UP/
TEST: MODULE SELECTION screen.
Different COM ET 200 screens for:
SYSTEM START–UP/TEST
DIAGNOSTICS
The three ET 200U interface modules have different manufacturer
identifications.
Extended diagnostics messages for the station status.
Using COM ET 200, the "422–8MA11" digital input module can now
also be entered as 16–channel input module or as 1–channel analog
input module.
Individual input of address IDs.
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
COM ET 200 (from version 4.0) and
IM 308–B from revision level 5 (printed on module) or from software
version 4.0 (indicated in COM ET 200).
Difference
Preface
Described in ...
Chapter 3
Table 4-1, Section 4.1.1 and
Table 5-1, Section 5.1.1
Section 4.2.1 and Section
5.2.1
Section 4.2 and Section 5.2
Section 4.2 and Section 5.2
Section 4.3 and Section 5.3
Section 4.3.3 and Section
5.3.3
Section 5.3.3
Table 5-1, Section 5.1.1
Section 5.1
v

Advertisement

Table of Contents
loading

Table of Contents