Using The Configuring Screen For Et 200U(Dp Standard) - Siemens SIMATIC S5 ET 200U Manual

ET 200U(DP Standard): AddressAssignm.,Starting–Up, DiagnosingFaultsUsing COM ET 200

5.1.1 Using the CONFIGURING Screen for ET 200U(DP Standard)

In the CONFIGURING screen, you assign for each ET 200U(DP Standard):
The following steps describe the procedure you must follow to configure
your ET 200U(DP Standard) slave station, from creating the configuration
data to storing it:
1. Make the appropriate entries in the ET 200 SYSTEM PARAMETERS
After you confirm the ET 200 system parameters with the <F6> (ENTER)
key
2. press <F8> to return to the FUNCTIONS screen.
3. From the FUNCTIONS screen, press <F2> to go to the CONFIGURING
Result: The CONFIGURING screen appears.
Program file selected: TEST@@@@ET.200
CONFIGURING
Station number: 3
F1 F2
Figure 5-1 ET 200U(DP Standard): CONFIGURING Screen (1)
5-4
the specific modules to specific slots of the slave station
and
the start addresses of the individual modules.
screen ( "ET 200 Distributed I/O System" Manual).
screen.
F3 F4
F5
SIMATIC S5 / COM ET 200
F6 F7 F8
ENTER HELP EXIT
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b