Standard Cleaning - Hardi MEGA VPZ NK Original Instruction Book

Table of Contents

Advertisement

Standard Cleaning

ATTENTION! For cleaning between spray jobs, where crops are not very sensitive towards chemicals just sprayed.
1. Engage the pump with tractor in idle, so that pump speed is as low as possible (approx. 250 - 280rpm).
2. Turn the suction valve towards
RinseTank content into the main tank.
It is important to have full agitation for approximately 20 seconds; and then close the agitation valve completely.
3. Turn the suction valve towards
45 seconds.
4. Switch all boom sections ON. Spray until air comes out of nozzles.
When the pressure drops, close the regulation valve by pressing the
yellow LED lights on the valve (this can take up to 10 seconds).
Press "auto" to have the system remove pressure spikes automatically before next start-up.
Repeat the Following Three Steps 5 Times:
5. Turn the suction valve towards
RinseTank content into the main tank.
6. Turn the suction valve towards
seconds.
7. Switch all boom sections ON. Spray until air comes out of nozzles.
When the pressure drops, close the regulation valve by pressing the
yellow LED lights on the valve (this can take up to 10 seconds).
Press "auto" to have the system remove pressure spikes automatically before next start-up.
and the pressure valve towards
and the pressure valve towards
and the pressure valve towards
and the pressure valve towards
5 - Operation
while transferring approximately 1/6 of the
with all boom sections OFF for approximately
button on the SetBox, until
while transferring approximately 1/6 of the
with all sections off for approximately 45
button on the SetBox, until
111

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mega vpz masterMega vpz meteor

Table of Contents