Table of Contents
Advertisement
Filling of Clean Water Tank
To fill the clean water tank:
1. Remove the tank lid (A).
2. Fill with clean water.
3. Refit the tank lid.
For use of water:
• Turn the lever to open the ball valve (B).
The water from this tank is for hand washing, cleaning of clogged
nozzles etc.
±
WARNING! Although the clean water tank is only filled with clean
water, this water must NOT be used for drinking.
ATTENTION! Only fill this tank with clean water! To avoid algae
developing in the clean water tank, always drain this tank, if the
sprayer is not in use for a longer period of time.
External Filling Device
The External Filling Device (if installed) is operated as follows:
1. Remove the cap (A) and connect a suction hose to the suction
manifold.
2. Turn pressure valve to "Main tank".
3. Turn suctionvalve to "External Filling Device".
4. Engage the pump and set PTO revolutions at max. 540 rpm.
5. The tank is now filled with water. Keep an eye on the liquid level
indicator.
6. Turn handle on suction manifold away from Filling Device to
discontinue filling process. Now disengage the pump. Disconnect
suction hose and replace the cap.
€
DANGER! Prevent contamination or injury. Do not open suction
valve towards the Filling Device, unless the pump is running and
the filling hose is connected. If this valve is opened without the
pump running, liquid will stream out of the coupler.
±
WARNING! Do not leave the sprayer while filling the tank, and
keep an eye on the level indicator in order NOT to overfill the
tank.
ATTENTION! Observe local legislation regarding use of filling device. In some areas, it is prohibited to fill from open
water reservoirs (lakes, rivers etc.). It is strongly recommended only to fill from closed reservoirs (mobile water tanks
etc.) to prevent contamination.
5 - Operation
95
Advertisement
Table of Contents
