Merchandiser Led Back-Lighting Panel; Ice Bank; Ice Sensor Probe - Cornelius NITROPRO MINI Service And Preventative Maintenance Manual

Nitropro Mini Service Manual
6.0 COMPONENT REPLACEMENT (Cont.)

6.8 Merchandiser LED Back-Lighting Panel

This panel is mounted to the cabinet door behind
the merchandiser window. Its control module can
be accessed by removing the light panel.
1) Shut off power to the dispenser and unplug the
power cord from the wall receptacle.
2) Remove the merchandiser window by pulling
firmly on the frame molding surrounding it, at
the top, as shown in Figure 6-10.
Figure 6-10 - Merchandiser LED Backlight Removal
3) Remove the corner screws securing the light
panel to the cabinet door.
4) Disconnect the wiring at the back of the panel.
5) Connect the new panel wiring and reinstall the
light panel in reverse order.
Publication Number: 548000106SER

6.9 Ice Bank

The Ice Bank consists of multiple components that
are replaceable. They include:

1) Ice Sensor Probe

2) Agitator/Pump Motor & Bath Impeller
3) Electronic Control Module
4) Refrigeration Components
6.9.1 Ice Sensor Probe
Figure 6-11 - Ice Sensor Probe
1) Shut off power to the dispenser and unplug the
power cord from the wall receptacle.
2) Remove the enclosure top panel and then the
left-side and rear access panels from the enclo-
sure.
NOTE: The ice sensor is located at the left-rear
of the enclosure (Fig. 6-12) and sensor removal
may be performed from the enclosure rear.
- 32 - © 2019, Cornelius Inc. All Rights Reserved