6.0 COMPONENT REPLACEMENT
This section provides instructions or guidelines on
replacing the various Nitropro Mini components.
6.1 Safety Precautions
WARNING!
Disconnect power to the unit before servic-
ing or replacing electrical components. Fol-
l ow a l l l o c k o u t / ta g o u t p ro c e d u re s
established by the user. Verify all power is
disconnected from the unit before perform-
ing any work. Failure to comply could result
in serious injury, death or damage to the
equipment.
CAUTION!
When replacing or testing electronic com-
ponents, be sure to wear a static strap con-
nected to chassis ground. This protects the
electronic components from any static dis-
charge while working on the unit. (This spe-
cifically applies to handling of a new Main
PCB or an Ice-Bank Controller module.)
6.2 Access Panel Removal
Follow the steps in the photos below to remove
the access panels in the required order.
© 2019, Cornelius Inc. All Rights Reserved
NOTE: Use the hinge cover to collect the panel
screws removed.
- 25 -
Nitropro Mini Service Manual
Publication Number: 548000106SER