Service And Maintenance; Preparing Unit For Shipping Or Relocating; Hood, Front Access Panel And Drip Tray Removal; Hood Removal - Cornelius VANTAGE Installation Manual

Pre-mix dispenser

Hide thumbs Also See for VANTAGE:

Specification sheet (2 pages)

Installation manual (19 pages)

Table Of Contents

Table of Contents

This section describes the service and maintenance procedures to be performed on the Unit.

IMPORTANT: Only qualified personnel should service the internal components or electrical wiring.

DANGER: To avoid possible fatal electrical shock or serious injury to the operator, it is

highly recommended that a GFI (ground fault circuit interrupt) be installed in the electrical

circuit for the 60 Hz Units. It is required that an ELCB (earth leakage circuit breaker) be

installed in the electrical circuit for the 50 Hz Units.

WARNING: Disconnect electrical power from the Unit to prevent personal injury before

attempting any internal maintenance. Only qualified personnel should service the internal

components or electrical wiring.

PREPARING UNIT FOR SHIPPING OR RELOCATING

CAUTION: The Unit is intended for indoor installation only. Do not install this Unit in an

outdoor environment which would expose it to the outside elements.

CAUTION: Before shipping, storing, or relocating this Unit, the product systems must be

sanitized and all sanitizing solution must be purged from the product systems. A freezing

ambient environment will cause residual water remaining inside the Unit to freeze resulting

in damage to internal components.

HOOD, FRONT ACCESS PANEL AND DRIP TRAY REMOVAL

(see Figure 4)

HOOD REMOVAL

CAUTION: Do not place or store anything on top of the Unit.

Remove screw securing hood, then lift hood straight up off the Unit. Make sure grille on top of the hood is

positioned over the refrigeration condenser coil when re-installing the hood.

IMPORTANT: Circulating air, required to cool the refrigeration assembly condenser coil is drawn in

through grille on top of the hood and is exhausted out through louvers on sides and back of the Unit.

FRONT ACCESS PANEL REMOVAL

Remove two screws securing the front access panel, then remove the panel.