Nitropro Mini Service Manual
6.0 COMPONENT REPLACEMENT (Cont.)
6.10 Tap Microswitches (Cont.)
5) Remove the 4 screws securing each tap-handle
switch assembly to the metal bracket and dis-
connect the wiring leads (Fig. 6-18).
Figure 6-18 - Tap Handle Microswitch Assembly
6) Remove the switch assembly and install the
new one. Mount the assembly on the support
bracket and reconnect the wiring leads.
7) Reinstall the plastic cover over the tap-handle
sw i tch m ou n t i ng s an d secu re wit h t h e
threaded retainer rings. Reinstall the tap han-
dles.
8) Verify operation of the taps.
Publication Number: 548000106SER
- 36 -
© 2019, Cornelius Inc. All Rights Reserved