Merchandiser Led Back-Lighting Panel; Ice Bank; Ice Sensor Probe - Cornelius Nitropro Mini Service And Preventative Maintenance Manual

Nitropro Mini Service Manual
6.8 M LED B
ERCHANDISER
This panel is mounted to the cabinet door behind the mer‐
chandiser window. Its control module can be accessed by
removing the light panel.
Figure 6‐10 ‐ Merchandiser LED Backlight Removal
1) Shut off power to the dispenser and unplug the power
cord from the wall receptacle.
2) Remove the merchandiser window by pulling firmly on
the frame molding surrounding it, at the top, as shown in
Figure 6‐10.
3) Remove the corner screws securing the light panel to the
cabinet door.
4) Disconnect the wiring at the back of the panel.
5) Connect the new panel wiring and reinstall the light panel
in reverse order.
6.9 I B
CE ANK
The Ice Bank consists of multiple components that are
replaceable. They include:

1) Ice Sensor Probe

2) Agitator/Pump Motor & Bath Impeller
3) Electronic Control Module
4) Refrigeration Components
Publication Number: 548000106SER
-L P
ACK IGHTING ANEL
‐ 30 ‐
6.9.1 Ice Sensor Probe
Figure 6‐11 ‐ Ice Sensor Probe
1) Shut off power to the dispenser and unplug the power
cord from the wall receptacle.
2) Remove the enclosure top panel and then the left‐side
and rear access panels from the enclosure.
NOTE: The ice sensor is located at the left‐rear of the enclo‐
sure (Fig. 6‐12) and sensor removal may be performed from
the enclosure rear.
It is recommended, for easier sensor‐cable routing and plug‐
ging/unplugging from the control module, to remove the air
compressor unit for improved access.
3) Unplug the sensor cable from the ice‐bank controller
module.
4) Remove the two black thumbscrews securing the ice sen‐
sor probe and then lift the sensor out of the ice bank. Note
its orientation.
5) Install the new sensor in the ice bank. Route its cable to
the controller module and plug it in.
© 2019, Cornelius Inc. All Rights Reserved