Installing External Hardware Options; External Floppy Drive; Creating A Customized Logo - Xycom 3400 Series Hardware Reference Manual

Installing External Hardware Options

This section explains how to install external hardware options.

External Floppy Drive

To avoid corruption, do not attach the external floppy drive with a disk
installed.
There are four screw holes on the back of the unit to mount an external floppy disk drive
(9000-EXF). Refer to Figure 3-7.
Make sure the floppy drive cable is able to reach the external floppy
connector on the system before making the cutout.

Creating a Customized Logo

You may place a customized label on the unit. Figure 3-10 provides the dimensions and
recommended requirements for a customized label.
Once you have created a customized label, place it over the "Xycom Automation" label
(inside the recessed area).
27
0.55 (13.97)
2.05 (52.07)
NOTE: All dimensions are in inches (mm)
RECOMMENDED MATERIAL: 0.007 (0.176) thick
polyester with 3M #468 adhesive on far side
Figure 3-10. Logo Label Dimensions
Note
Note
0.06 (1.52)
(4 Places)
Your Logo On
Entire Surface