Knife Operation; Clamp Operation; Needle Bar Forward/Backward Adjustment After Sewing Suspension - SunStar SPS/E-BH6100 User Manual

4) Knife operation

When the sewing READY lamp is off, the knife on/off key is
activated. When pressed, the lamp is on or off.
•Lamp on : The knife can operate.
•Lamp off : The knife can not operate.

5) Clamp operation

When the READY lamp is off, and either Clamp Up/Down
( ) or the right hand switch is pressed, the clamp starts
operation.
•Lamp on, right hand switch pressed: clamp down
•Lamp off, right hand switch pressed: clamp up
In case of changing to
because lowering and sewing is operating with the left hand switch at the same time.
Caution

6) Needle bar forward/backward adjustment after sewing suspension

① When the suspension switch is pressed in the middle of sewing,
sewing is stopped, and a new screen appears.
② If the suspension switch is turned counter-clockwise and
returned to the original position, the screen goes back to the
initial sewing screen.
③
Press "Up" or "Down" key to make the needle bar move
forward or backward. Likewise, the needle bar could be
relocated to a desired position by using the Up or Down key.
④
When the start button is pressed, sewing resumes from the newly
set needle bar position.
16
"One Switch"mode, there is no the presser foot lowering or raising motion
[The knife can operate] [The knife can not operate]
(Clamp down)
Sewing
direction
Back Stitch
(Clamp up)
OR
↓