11) Function Keys
Classification
Function Keys
WRITER
HOME(ESC)
RETURN
•Function keys are used within the [DATAINFO] routine.
•Press READY at the basic pattern routine to generate basic patterns. Then the display returns to
the initial screen.
•When creating patterns composed of multiple patterns, press READY at the parameter routine by
sector. If only one parameter is changed and READY is pressed, the remaining parameters of the
Caution
new pattern are same as before.
12) A front / rear knife motion
①
During pressing " DOWN " key four times in the state of
extinguished stitching preparation lamp, the screen flicker at the
"AFTER."
AFTER : A rear knife motion
BEFORE : A front knife motion
②
Set the knife motion mode you want by using ◀ (+) and ▶ (-)
keys then press an ENTER key.
(ex. : BEFORE)
③
If you press the ENTER key, knife motion mode will be set.
20
[DATAINFO] When this key is pressed within the routine, patterns are immediately created, and
the initial screen appears.
[DATAINFO] When this key is pressed within the routine, the changed parameter values are not
saved, and the initial screen appears.
[DATAINFO] When this key is pressed within the routine, the screen returns to the previous
stage.
Description
↓
↓
OR
↓