1-3) Machine Operation; 1-4) Repair - SunStar SWF/C Series User Manual

1-3) MACHINE
OPERATION
WARNING

1-4) REPAIR

DANGER
The SWF Automatic Embroidery Machine is designed for applying
embroidery to fabric and other similar materials.
Pay careful attention to the
parts of the machine. Make sure to observe the following when operating
the machine:
01) Read thoroughly and fully understand the manual before operating the
machine.
02) Dress for safety. Long and unbound hair, jewelry such as necklaces,
bracelets, and wide sleeves can get caught in the machine. Wear shoes
with non-slip soles.
03) Clear all persons from the machine before turning on the power.
04) Keep your hands or head away from the moving parts of the machine such
as needle, hook, take-up lever, and pulley when the machine is in
operation.
05) Do not remove the safety cover on the pulley or shaft when the machine is
in operation.
06) Be sure the main power is turned off and the power switch is set to OFF
before opening the cover of any electrical component or control box.
07) Be sure the main switch is OFF before manually turning the main shaft.
08) Turn the machine off when threading needles or inspecting the finished
embroidery.
09) Do not lean against the cradle or place your fingers near the guide grooves
of the frame.
10) The machine noise may exceed 85db when it is run at a maximum speed.
It is not higher than the standard level, but you may need earplugs or
sound-proof facilities for the operator and other workers.
Only SWF-trained and selected repair engineers should do repair work.
1) Turn OFF the power before cleaning or repairing the machine. Wait for 4
minutes so the machine electricity is completely discharged.
[CAUTION]
It takes about 10 minutes after turning off the main switch before the
electricity is fully discharged from X/Y main shafts and the drive box.
2) Do not change the settings or any parts on the machine without
confirmation from SWF. Such change may cause safety accidents.
3) Use only SWF parts when repairing your machine.
4) Replace all safety covers when you are finished with your repair.
1-3
and
WARNING CAUTION
stickers on certain