6-3-2) Square bartack pattern
①
Check that the Ready lamp is off, and Press DOWN to select
DATAINFO. Press ENTER and the initial screen for parameter
setting appears.
②
Press UP or Down on the initial parameter setting screen and
select '2. Pattern'.
③
Press ENTER and you will see a screen for selecting button
shapes. Press UP or DOWN to select the desired pattern and
press ENTER.
1 : Taper (Taper Pattern)
2 : Tack (Square Bartack Pattern)
3 : Radial (Radiation pattern shape)
4 : Eyelet (Eyelet Pattern)
④
The screen for creating new patterns appears.
The values for up, down, bartack and zigzag parts shall be set
respectively to create a pattern.
1 : Up Bar (Up Bartack)
2 : Zigzag (Zigzag)
3 : Dn Bar (Down bartack)
※
After setting the common parts of ① , ② , ③ , set the individual values for the up bartack part, zigzag and down bartack part respectively.
•To create patterns with default values, press READY at the step ④.
•"4:Eyelet" is displayed only when A-16 of the Parameter Group is changed to "1:enabled". When
"4:Eyelet" is displayed, it is possible to produce the eyelet pattern.
Caution
32
↓
↓
OR
↓