6-7) Lower bar tack correction
①
Make sure that the READY lamp is off and press the DOWN
key six times. It makes DATAINFO blink. Press ENTER and
the initial parameter screen appears.
②
Select '6' by using the UP or DOWN key.
③ The display moves to the previous screen and '1' blinks on the
screen. Select '1' using UP or DOWN to compensate the slant
value of taper and press ENTER.
④
The screen goes back to the previous one. Select [RETURN]
and press ENTER to end the slant-related setting.
⑤ The display moves to the previous screen and '1' blinks on the
screen. Select '2' using UP or DOWN to compensate the slant
value of the square bartack and press ENTER.
⑥ The display moves to the previous screen and '1' blinks on the
screen. Select '1'using UP or DOWN to compensate the X-
direction value of the square bartack and press ENTER.
⑦ When a new screen appears, select the desired value using ◀
(+) and ▶(-) and press ENTER. Then the O.K.! message is
displayed.
+ direction :The square bartack pattern moves to the right side.
- direction: The square bartack pattern moves to the left side.
⑧ The display moves to the previous screen and '2' blinks on the
display. Select '2'using UP or DOWN to compensate the Y-
direction value of the square bartack and press ENTER.
⑨ When a new screen appears, select the desired value using ◀
(+) and ▶(-) and press ENTER. Then the O.K.! message is
displayed.
- direction: The pattern gets narrower.
↓
↓
OR
↓
↓
OR
↓
OR
↓
↓
OR
↓
↓
OR
↓
↓
OR
↓
↓
OR
↓
↓
OR
↓
↓
51