Error Messages And Troubleshooting - SunStar SPS/E-BH6100 User Manual

8 8

Error Messages and Troubleshooting

error
code
Error in the needle bar's highest stop position
(Either after the sewing is finished or when the hand pulley
3
is spined by hand, the needle bar is not located in the right
position (the highest point of the needle bar))
Limit error
4
(In case where the pattern size goes out of the size range of X, Y)
Knife motion error
5
X's original point error
6
Chain sewing error
8
(When the chain sewing setting is wrong)
Exceed the total number of stitches (If the total stitch
9
number goes beyond 300.)
14
Bad SPMS fan operation
15 Failure in properly recognizing the main motor type
16
Y's original point error
26
θ 's (rocking) original point error
60, 61 Synchronizer contact error
70
X Servo Step Moter Erro
71 Y Servo Step Moter Error
72
θ (rocking) Servo Step Moter Error
126
Y Servo Step Moter Error
127
Encoder AB error
128
Encoder off line error
129 Main shaft motor overload
130 Synchronizer signal error
131 Main Shaft Over Current Error
133 IPM Error
9999
Main Shaft Over Current Error
Vol tage Over Load Voltage Over Load
Vol tage Under Load Voltage Over Load
Description Cause and Troubleshooting
•Rotate the hand pulley and place the thread take-up to
the highest position.
•Create the pattern again.
•Check the solenoid and the air pressure.
•Check the sensor and the sensor plate.
•Check the X Sensor.
•Check the X Sensor connecter.
•Without setting the pattern number in Set-No, set the
connection sewing at 'On'.
•Create the pattern again.
·Fan checking
·Encoder cable and main shaft motor check
•Check the Y Sensor.
•Check the Y Sensor connecter.
•Check the θSensor.
•Check the θSensor connecter.
•Check the bad connector connection.
•Check the encoder cable.
•Check step X boarde
•Check step Y boarde
•Check step θ boarde
•Check the bad connector connection.
•Check the encoder cable.
•Check the bad connector connection.
•Check the encoder cable.
•Check the bad connector connection.
•Check the encoder cable.
•Check the main shaft motor cable.
•Check the overload.
•Check the synchro signals.
•Check Main Shaft board
•Check Main Shaft board
•Check Main Shaft board
•Check board and cable
•Check board and cable
73