6-9) Set the Back-Tack function
①
Check that the sewing READY lamp if off, and press the
DOWN key six times. It makes DATAINFO blink. Press
ENTER and then the initial parameter setup screen appears.
②
On the initial parameter setup screen, use the UP or DOWN
key and select '8:BT_STI'. Press ENTER.
③
A new screen pops up and '1' blinks. Use the UP or DOWN
key to select '1' and press ENTER to set the starting back-tack
value.
④
Use ◀ (+) and ▶ (-) to select the desired value and press
ENTER. Then the O.K.! message is displayed on the screen.
(setting range: 0 ~ 2)
⑤
The screen moves back to the previous one and '1' blinks
again. Select '2' and follow the same process as above to set
the ending back-tack value.
⑥
When trying to end the back-tack setting, use the DOWN key
to select [RETURN] and press ENTER.
56
↓
↓
OR
↓
↓
OR
↓